1. Q:
    2. How do I log into my wifi range extender?
    1. A:
    2. Please select your Range Extender:


      - DAP-1320

      - DAP-1330/DAP-1520/DAP-1620/DAP-1860/DAP-1720

      - DCH-M225




       

      DAP-1320


      Step 1: Plug in the DAP-1320

      Note: The light should turn red and then start blinking orange or stay solid green (if already setup)



      Step 2: From a wireless computer/device, scan for available networks and connect to the DAP-1320 Wireless Signal (or pre-defined SSID if this this a new setup)


      (The Pre-Defined SSID is located on the Configuration note supplied with the DAP-1320 and on the bottom of the DAP-1320) example: Dlink-6DFC .




      Step 3: Open a Web browser and go to: http://dlinkap.local . You should be directed to the DAP-1320 configuration page


      The default username is admin and there is NO password


      Note: If you have changed your password and do not remember it, you will need to reset the DCH-M225 to factory default settings. Click here for reset instructions- How do I factory reset my wifi range extender






       

      DAP-1330/DAP-1520/DAP-1620/DAP-1860


      Step 1: Plug in the extender


      Note: The light on the front of the extender should turn red and then start blinking orange (or green if already configured)



      Step 2: From a wireless computer/device, scan for available networks and connect to the pre-defined SSID
      (Located on the Configuration note supplied with the extender and on the bottom of the extender) example: Dlink-68BE.





      Step 3: Open a Web browser and go to: http://dlinkap.local or http://dlinkap . You should be directed to the extender configuration page


      Note: If this is the first time configuring the extender, the Setup Wizard will appear. If the device has been configured previously, the device login page will be shown.


      By default, there is no login password


      Note: If you have changed your password and do not remember it, you will need to reset the extender to factory default settings. Click here for reset instructions- How do I factory reset my wifi range extender





       

      DCH-M225


      Step 1: Plug in the DCH-M225

      Note: The light should turn red and then start blinking orange or stay solid green (if already setup)



      Step 2: From a wireless computer/device, scan for available networks and connect to the DCH-M225 Wireless Signal (or pre-defined SSID if this this a new setup)


      (The Pre-Defined SSID is located on the Configuration note supplied with the DCH-M225 and on the bottom of the DCH-M225) example: Dlink-6DFC .




      Step 3: Open a Web browser and go to: http://dlinkap.local . You should be directed to the DCH-M225 configuration page


      By default there is NO password


      Note: If you have changed your password and do not remember it, you will need to reset the DCH-M225 to factory default settings. Click here for reset instructions- How do I factory reset my wifi range extender






Did you find this article useful? Yes No